Feeling like my nails have been neglected as of late, I decided to do a fun water marble last night. But rather than just random patterns, I opted for a design that would allow me to get a similar look on each nail.
Using Sexy in the City (blue polish by China Glaze) and Paper Mache (white polish from Fingerpaints) I came up with this:
If Nail Marbling is something new for you, please check out my nail marbling introduction here complete with lots of photos.
- In order to recreate this look you will need: scotch tape, a cup of room temperature water, toothpicks, white nail polish and a second contrasting polish of your choice.
- Prep your nails with two coats of your white polish.
- Scotch tape around your nails to make your life easier later.
- Begin dropping your polish into the water, alternating white and your second colour. Create a bullseye that looks something like this:
- Take a toothpick and create the design of your choice. For my burst design, drag your toothpick in towards the centre, creating an almost flower like shape. (If your centre gets super messy, take your toothpick and push it straight down into the centre and pull it back out, keeping your toothpick straight. This will clean up your centre.)
- Now, with your nail parallel to the surface of the water, hovering over the very centre of your design, push it down into the water. Then, using your toothpick clean up the rest of the polish from the surface of the water (leaving your finger submerged.)
- Once the surface of the water is clean, go ahead and bring your finger out of your water.
- Give your fingers a bit of time to dry before removing the tape. I like to do a complete hand before I remove the tape.
- Then, all you need to do is a little bit of clean up. Using a q-tip and a touch of nail polish remover, clean up the areas that your tape didn’t protect.
- Viola! A Burst of Blue manicure.